Toro Groundsmaster 5900 Series Service Manual page 412

Removal (continued)
Installation
Electrical System: Service and Repairs
g298626
1. 24 Volt alternator
2. Positive (+) terminal
3. Circuit diode (green)
4. Disconnect the four (4) wire harness connectors from the alternator
287).
5. Remove the alternator drive belt (see
Compressor Drive Belt (page
6. Loosen the four (4) alternator mounting nuts and remove the nuts, hardened
washers, plastic washers, plastic isolators and cap screws.
7. Remove the alternator from the machine.
Contact your Authorized Toro Distributor or a Delco Remy authorized Dealer
for 24 Volt alternator service information.
8. Remove the pulley from the alternator shaft only if the alternator is being
replaced.
9. Inspect the plastic washers and isolators for wear or damage and replace
if necessary.
10. Inspect the rubber boots over each of the wire harness connectors for wear
or damage and replace if necessary.
1. If previously removed, install the alternator pulley and tighten the flange nut
from 95 to 108 N·m (70 to 80 ft−lb).
The alternator body must be isolated from the machine frame.
Figure 287
4. Negative (−) terminal (alternator body)
5. Remote sense relay (violet)
24 Volt Alternator/Air Conditioning
6–147)).
IMPORTANT
Page 6–150
(Figure
Groundsmaster ® 5900 & 5910
16227SL Rev B