Toro Groundsmaster 5900 Series Service Manual page 94

Engine Removal (continued)
Yanmar Diesel Engine: Service and Repairs
8. To prevent contamination of hydraulic system, thoroughly clean exterior of oil
cooler, fittings and hydraulic hoses prior to disconnecting hydraulic hoses.
9. Disconnect hydraulic hoses from the oil cooler and install caps or plugs on
fittings and hoses.
10. Remove the cooler frame assembly with the radiator and fan assembly, oil
cooler and fan assembly, air filter and plenum assembly, coolant reservoir
and windshield washer reservoir attached
A. Record the location of cable ties, clamps and clips used to secure the
electrical harness to the cooler frame.
B. Disconnect the windshield washer reservoir pump from the wire harness
(GM 5910 only).
C. Disconnect two (2) oil cooler fans from the wire harness.
D. Disconnect air filter service indicator from the wire harness.
E. Disconnect two (2) radiator fans from the wire harness.
F. Disconnect two (2) radiator fans from the wire harness.
G. Support the cooler frame assemble from overhead and remove the
fasteners securing the cooler frame to the machine. Lift the cooler frame
assembly from the machine.
11. Record the location of cable ties, clamps and clips used to secure the
electrical harness to the engine and prepare the engine for removal:
A. Disconnect the diesel particulate filter (DPF) from the wire harness.
B. Disconnect the alternator from the wire harness and the positive (+) cable.
1 2
6
g287542
1. Lock nut
2. Fusible link
3. Starter solenoid
4. Heat shield
5. Flange head screw (3)
C. Remove the heat shields from around the starter motor and disconnect
the positive (+) battery cable, fusible link and wire harness
(Figure
3 4 5
7 8
Figure 25
6. Positive battery cable
7. Wire harness
8. Cap screw
9. Flange head screw (2)
10. Heat shield
Page 4–26
24):
9 10
(Figure
Groundsmaster ® 5900 & 5910
16227SL Rev B
25).