Toro Groundsmaster 5900 Series Service Manual page 322

Fuse Identification, Location and Function (continued)
Fuse Testing
Electrical System: Component Testing
g288446
Loosen the knobs and remove the cover at the front of the cab headliner to
access the operator cab fuses (Groundsmaster 5910)
202).
•
Fuse 1F1 (20 Amp) supplies power to the cab work lights.
•
Fuse 1F2 (25 Amp) supplies power to the heater/air conditioner fan circuit.
•
Fuse 1F3 (30 Amp) supplies power to the air conditioner circuit.
•
Fuses 1F4 is unused and available for optional equipment. This fuse can
be used for a radio or other cab accessory that is mounted in or near the
cab headliner.
•
Fuse 2F1 (15 Amp) supplies power to the windshield wiper.
•
Fuse 2F2 (15 Amp) supplies power to the cab dome light.
•
Fuses 2F3 and 2F4 is unused and available for optional equipment. These
fuses can be used for a radio or other cab accessories that are mounted
in or near the cab headliner.
1. Make sure that key switch is OFF and key is removed from switch.
2. Turn the batter−disconnect switch to the OFF position.
3. Remove fuse from fuse block for testing. Fuse should have continuity across
the terminals.
4. After fuse testing is completed, install fuse and secure cover.
5. Turn the battery−disconnect switch to the ON position before returning the
machine to service.
4 3 2
Figure 202
Page 6–60
1
1F
2F
FRONT
(Figure 201 and
Groundsmaster ®
16227SL Rev B
Figure
5900 & 5910