Infocenter Display - Toro Groundsmaster 5900 Series Service Manual

InfoCenter Display

Groundsmaster ® 5900 & 5910
16227SL Rev B
g288346
1. Operator control console
The Groundsmaster InfoCenter Display is a LCD device that is located in the
Operator control console. The Info- Center display provides information for
the machine operator during machine operation, provides electrical system
diagnostic assistance for technicians and allows inputs for adjustable machine
settings.
Power for the InfoCenter is available when the main power relay is energized
(key switch is in the START or RUN position). A 2 Amp fuse (F−B5) protects the
Info- Center power circuit. A CAN bus network involving the master and slave
Toro Electronic Controllers (TECs), the Yanmar engine ECU and the InfoCenter
is used to communicate machine information to and from the Info- Center display.
Note: The TEC controllers and the InfoCenter Display used on the
Groundsmaster 5900 and 5910 are matched for correct machine operation. If
any of these components are replaced for any reason, system software needs to
be reprogrammed (contact an Authorized Toro Distributor for assistance).
Figure 138
2.

InfoCenter Display

Page 6–9
2
1
Electrical System: InfoCenter Display