Cutting Deck Motor Assembly
Hydraulic System: Service and Repairs
(Figure
106) (continued)
16. Place front flange of the motor into a vise with soft jaws and alternately torque
the cap screws 45 N·m (33 ft−lb).
17. Remove motor from vise.
18. Place a small amount of clean hydraulic fluid in the inlet of the motor and
rotate the drive shaft away from the inlet one revolution. If any binding is
noted, disassemble the motor and check for assembly problems.
Page 5–124
Groundsmaster
®
5900 & 5910
16227SL Rev B