Toro Groundsmaster 5900 Series Service Manual page 311

Adjustment (continued)
Traction Pedal Neutral Adjustment
Groundsmaster ® 5900 & 5910
16227SL Rev B
6. For machine serial numbers above 316000200 adjust the wing deck switches
as follows (Figure 190):
A. Raise the wing deck to a 12 degree angle and safely support the deck to
prevent it from lowering during the adjustment procedure.
B. The center of the switch sensing eye should be 6.3 mm (0.25 in) above
the upper edge of the sensing plate. Loosen the sensing plate mounting
fasteners to adjust the plate as needed.
C. Loosen the lock nuts securing the switch to the switch bracket and set
the position switch so the correct clearance exists between the target
eye and the sensing plate. Tighten the position switch lock nuts from 19
to 21 N·m (14 to 16 ft−lb).
1
2
6
g288434
1. Bar graph
2. Position indicator bar
3. Reverse switch icon
The traction pedal includes a neutral assembly that is used to adjust the traction
pedal neutral position. Traction pedal adjustment may be necessary to ensure
the traction pedal movement provides the correct full reverse and full forward
positions for the traction pedal position sensor. Use the InfoCenter display to
check traction pedal adjustment using the following procedure:
1. Park machine on a level surface, lower cutting decks and stop engine.
2. Turn key switch to RUN but do not start engine.
3. Use the InfoCenter Display to access the Traction Pedal screen (see
InfoCenter Display −
4. Press button 2 from the Traction Pedal screen to view the Neutral screen
(Figure 191).
CALIBRATED
2.18 V 2.25 V
2.23 V
3
5
Figure 191
4. Forward switch icon
5. Neutral voltage
6. Midpoint voltage
SERVICE (page 6–14)
Page 6–49
2.33 V
4
Screens).
Electrical System: Adjustments