To Start; To Engage Pto; To Set Cruise Control - Toro Groundsmaster 5900 Series Service Manual

TO START

TO ENGAGE PTO

TO SET CRUISE CONTROL

Groundsmaster ® 5900 & 5910
16227SL Rev B
Advisories are available for the following functions:
The TO START advisory identifies that the engine starter will not engage after
the key switch is turned to the START position.
#5 DISENGAGE The PTO switch is in the engaged position and must be disengaged
PTO: before starter will operate.
#6 MOVE The traction pedal position sensor is not in the neutral position.
TRACTION PEDAL
TO NEUTRAL:
#7 MUST BE Operator needs to be in seat or parking brake switch needs to be in the
SEATED OR SET engaged position before starter will operate.
PARKING BRAKE:
#8 DISENGAGE One of the three (3) deck raise/lower switches is in the raise or lower
DECK SWITCH: position and must be set to the middle (neutral) position before starter
will operate.
#9 TURN KEY Power to the control system must be recycled before starter will operate.
SWITCH OFF
THEN ON:
The TO ENGAGE PTO advisory identifies that the PTO will not engage when
the PTO switch is pulled out.
#102 MUST BE IN Machine is set to high range traction speed and needs to be in low range
LOW RANGE: traction speed before PTO will engage.
#106 OPERATOR Operator needs to be in seat to engage PTO.
MUST BE
SEATED:
#107 LOWER No cutting decks are fully lowered. At least one deck must be fully lowered
DECKS: before the PTO will engage.
#108 LET ENGINE Engine coolant temperature must be less than 102 ºC (216 ºF) before
COOL: PTO will engage.
#109 REQUIRES CAN communication between the two (2) Toro Electronic Controllers
SERVICE: (TEC) must be reestablished before the PTO will engage.
The TO SET CRUISE CONTROL advisory identifies that the cruise control will
not engage when the cruise control switch is pressed.
#202 INCREASE Forward ground speed must be increased before cruise control can be
GROUND SPEED: engaged.
Page 3–17 Troubleshooting: