Blade Spindle Removal (continued)
Blade Spindle Installation
Cutting Decks: Service and Repairs
8. Lift spindle assembly from deck. See
additional spindle service information.
1. Position spindle on cutting deck noting orientation of grease fitting
331). Secure spindle assembly to deck with correct fasteners
2. Install cutting blade, anti−scalp cup and blade bolt to spindle. Tighten blade
bolt from 119 to 146 N·m (88 to 108 ft−lb).
3. Slowly rotate cutting blades to verify that blades do not contact any deck
components.
4. Use a ⅜" or ½" drive ratchet or breaker bar to relieve idler pulley tension
and install drive belt(s).
5. If drive spindle was removed, install hydraulic motor to cutting deck. See
Cutting Deck Motor (page 5–118)
6. Install all cutting deck covers.
Blade Spindle Service (page 8–17)
for additional information.
Page 8–16
for
(Figure
(Figure
332).
Groundsmaster
®
5900 & 5910
16227SL Rev B