Operator Seat
g299266
1.
Cap screw
2.
Lock washer
3.
Cap screw
4.
Flat washer (4)
Operator Seat Removal
Chassis: Service and Repairs
5.
Spacer
6.
Seat belt receptacle
7.
Coupling nut
8.
Retractable seat belt
(Figure
316)
1. Park machine on a level surface, lower cutting decks, stop engine and
remove key from the key switch.
2. Disconnect seat electrical connector from machine wire harness.
3. Remove flange nut and carriage screw (item 10) that secure support bracket
at front right corner of seat to console support.
4. Remove cap screw (item 1) and lock washer that secure coupling nut (item
7) to console support.
5. Remove cap screw (item 3) and flat washer that secure seat to console
support. Remove spacer, seat belt receptacle (item 6) and flat washer from
between seat and console support.
6. Remove four (4) Torx head screws
suspension. Note that the screw near the seat adjustment handle is longer
than the other three screws.
7. Lift seat from seat suspension and remove from machine.
Figure 316
10.
11.
(Figure
Page 7–40
9.
Cap screw
Carriage screw
Flange nut
317) that secure seat to seat
Groundsmaster
16227SL Rev B
®
5900 & 5910