Toro Groundsmaster 5900 Series Service Manual page 211

Traction Control Manifold Removal
Traction Control Manifold Installation
Groundsmaster ® 5900 & 5910
16227SL Rev B
(Figure
Make sure hydraulic manifold is properly supported before removing
the mounting screws. The hydraulic manifold assembly weighs
approximately 50 kg (110 lb).
5. Remove hydraulic manifold from the frame.
6. If hydraulic fittings are to be removed from manifold, mark fitting orientation to
allow correct assembly. Remove fittings from manifold and discard O−rings.
(Figure
1. If fittings were removed from manifold, lubricate and place new O−rings onto
fittings. Install fittings into manifold openings using marks made during the
removal process to properly orientate fittings. Tighten hydraulic fittings to
torque value provided
for hydraulic fittings, see
Thread O-Ring Fittings) (page
2. Position traction control manifold in the frame and secure with the mounting
bracket and all manifold mounting cap screws. Tighten the cap screws finger
tight only at this time.
3. Remove caps and plugs from fittings and tubes (hard lines). Using labels
placed during removal, properly connect hydraulic tubes to manifold (see
Installing Hydraulic Hoses and Tubes (O-Ring Face Seal) (page
4. Tighten manifold mounting cap screws from 58 to 72 N·m (43 to 53 ft−lb).
5. Remove caps and plugs from fittings and hoses (soft lines). Using labels
placed during removal, properly connect hydraulic hoses to manifold (see
Installing Hydraulic Hoses and Tubes (O-Ring Face Seal) (page
6. Connect wire harness connector to the solenoid valve and temperature
sender.
7. Make sure hydraulic tank is full. Add correct oil if necessary.
8. Check hydraulic system for leaks before returning the machine to service.
98) (continued)
CAUTION
98)
(Figure 99). For information on tightening procedures
Installing the Hydraulic Fittings (SAE Straight
5–9).
Page 5–111
5–7)).
5–7)).
Hydraulic System: Service and Repairs