Toro Groundsmaster 5900 Series Service Manual page 254

Steering/Lift Control Manifold Installation
Hydraulic System: Service and Repairs
B. If fitting was removed from manifold port LS (OR1) C3 (OR3), C2 (OR5)
and C5 (OR7), install appropriate orifice in port before installing fitting.
C. Install fittings into manifold openings using marks made during the
removal process to properly orientate fittings.
D. Tighten hydraulic fittings to torque value provided
information on tightening procedures for hydraulic fittings, see
the Hydraulic Fittings (SAE Straight Thread O-Ring Fittings) (page
2. Position steering/lift control manifold to the frame and secure with four (4)
flange head screws.
3. Remove caps and plugs from fittings and hoses. Properly connect hydraulic
lines to manifold (see
Seal) (page 5–7)).
4. Install hydraulic filter to manifold:
A. Lubricate the new filter gasket and fill the filter with hydraulic fluid.
B. Ensure that the filter mounting area is clean and screw the filter on until
the gasket contacts the manifold; then tighten the filter an additional 1/2
turn.
5. Using labels placed during removal, correctly connect wire harness
connectors to solenoids on lift control manifold.
6. Make sure hydraulic tank is full. Add correct oil if necessary.
7. Check hydraulic system for leaks before returning the machine to service.
8. Secure RH lower shroud to machine. Lower and secure hood.
(Figure 130) (continued)
Installing Hydraulic Hoses and Tubes (O-Ring Face
Page 5–154
(Figure 131). For
Installing
5–9).
Groundsmaster ® 5900 & 5910
16227SL Rev B