Toro Groundsmaster 5900 Series Service Manual page 467

Front Cutting Deck Installation
Groundsmaster ® 5900 & 5910
16227SL Rev B
(Figure
1. Position machine on a clean, level surface. Lower front lift arms, stop engine
and remove key from the key switch.
2. Position the cutting deck to the lift arms.
3. Align lift arm support hub to cutting deck. Make sure that slotted hole in the
support hub is toward the rear of the deck.
4. Position thrust washer (item 9) between the lift arm and the rear, slotted hole
of the support hub and secure lift arm support hub to deck with cap screws
(item 7), flat washers, plate and lock nuts. Tighten fasteners from 128 to
157 N·m (94 to 116 ft−lb).
5. Start engine and raise deck slightly. Stop engine and remove key from the
key switch.
6. Install clevis pins and hairpins that secure the height−of−cut chains to the
rear of the cutting deck.
7. Position damper to mount on cutting deck. Install spacer and spring pin to
secure damper to deck
8. Start engine and lower deck to ground. Stop engine and remove key from
the key switch.
9. Install hydraulic motor to cutting deck (see
10. Install all removed cutting deck covers.
11. Lubricate grease fittings on cutting deck and lift arm assemblies (see
Operator's Manual).
322)
(Figure 323).
Page 8–5
Cutting Deck Motor (page
Cutting Decks: Service and Repairs
5–118)).