Toro Groundsmaster 5900 Series Service Manual page 295

INPUT/OUTPUT (continued)
Groundsmaster ® 5900 & 5910
16227SL Rev B
•
Cruise control switch in the ON position (CRUISE ON/OFF ON).
•
Cruise control switch depressed to engage cruise control (CRUISE ENGAGE
ON).
If the proper inputs exist, the following outputs should occur
•
Cruise control will be engaged (CRUISE ACTIVE ON).
Engine Run
g288331
When the key switch is in the RUN position (KEY RUN ON), the following output
should occur (Figure 168):
•
The electric fuel pump should be energized (OK RUN ON).
Note: The engine will not start if the operator is not in the seat and the parking
brake is disengaged, the PTO is engaged and the traction pedal is in forward or
reverse.
g288332
To start the engine, the following inputs and qualifiers are required
•
Operator seat needs to be occupied (SEAT ON) or the parking brake needs
to be applied (PARKING BRAKE ON).
•
PTO switch disengaged (PTO ENABLED OFF).
•
Traction pedal in neutral (FORWARD RANGE OFF) and (REVERSE RANGE
OFF).
•
Key switch needs to be turned to the START position (KEY START ON) and
(KEY RUN ON).
Figure 168
(RUN)
Figure 169
(START)
Page 6–33
(Figure 167):
(Figure
Electrical System: InfoCenter Display
169):