Encoder 2 Configuration - ABB ACS880 Firmware Manual

402 Parameters
No. Name/Value
Even
92.46 Hiperface baud rate
4800 bits/s
9600 bits/s
19200 bits/s
38400 bits/s
92.47 Hiperface node
address
0...255
93
93 Encoder 2
configuration
93.01 Encoder 2 type
None configured
TTL
TTL+
Absolute encoder
Resolver
HTL
HTL 1
HTL 2
93.02 Encoder 2 source
Module 1
Module 2
93.10 Pulses/rev
93.10 Sine/cosine number
93.10 Excitation signal
frequency
93.11 Pulse encoder type
ghv Vertriebs-GmbH | Am Schammacher Feld 47 | 85567 Grafing | Telefon + 49 80 92 81 89 0 | info@ghv.de | www.ghv.de
Description
Even parity indication bit, one stop bit.
(Visible when an absolute encoder is selected)
Defines the transfer rate of the link with a HIPERFACE
encoder.
Typically this parameter need not be set.
4800 bit/s.
9600 bit/s.
19200 bit/s.
38400 bit/s.
(Visible when an absolute encoder is selected)
Defines the node address for a HIPERFACE encoder.
Typically this parameter need not be set.
HIPERFACE encoder node address.
Settings for encoder 2.
Notes:
• The contents of the parameter group vary according to the
selected encoder type.
• It is recommended that encoder connection 1 (group
Encoder 1 configuration) is used whenever possible since
the data received through that interface is fresher than the
data received through connection 2 (this group).
Selects the type of encoder/resolver 2.
None.
TTL. Module type (input): FEN-01 (X31), FEN-11 (X41) or
FEN-21 (X51).
TTL+. Module type (input): FEN-01 (X32).
Absolute encoder. Module type (input): FEN-11 (X42).
Resolver. Module type (input): FEN-21 (X52).
HTL. Module type (input): FEN-31 (X82).
HTL. Module type (input): FSE-31 (X31).
HTL. Module type (input): FSE-31 (X32). Not supported at the
time of publication.
Selects the interface module that the encoder is connected to.
(The physical locations and types of encoder interface
modules are defined in parameter group
settings.)
Interface module 1.
Interface module 2.
(Visible when a TTL, TTL+ or HTL encoder is selected)
See parameter 92.10 Pulses/revolution.
(Visible when an absolute encoder is selected)
See parameter 92.10 Sine/cosine
(Visible when a resolver is selected)
See parameter 92.10 Excitation signal
(Visible when a TTL, TTL+ or HTL encoder is selected)
See parameter 92.11 Pulse encoder
92
91 Encoder module
number.
frequency.
type.
Def/FbEq16
1
4800 bits/s
0
1
2
3
64
-
None
configured
0
1
2
3
4
5
6
7
Module 1
1
2
2048
0
1 kHz
Quadrature