ABB ACS880 Firmware Manual page 394

394 Parameters
No. Name/Value
91.10 Encoder parameter
refresh
Done
Refresh
91.11 Module 1 type
None
FEN-01
FEN-11
FEN-21
FEN-31
FSE-31
91.12 Module 1 location
Slot 1
Slot 2
Slot 3
4...254
91.13 Module 2 type
None
FEN-01
FEN-11
FEN-21
FEN-31
FSE-31
91.14 Module 2 location
Slot 1
Slot 2
Slot 3
4...254
91.21 Module 1 temp
sensor type
None
PTC
ghv Vertriebs-GmbH | Am Schammacher Feld 47 | 85567 Grafing | Telefon + 49 80 92 81 89 0 | info@ghv.de | www.ghv.de
Description
Validates any changed encoder interface module parameters.
This is needed for any parameter changes in groups 90...93
to take effect.
After refreshing, the value reverts automatically to Done.
Notes:
• Permanent magnet motors only: The drive will perform a
fresh autophasing routine (see page 59) at next start if the
motor feedback encoder settings have been changed.
• The parameter cannot be changed while the drive is
running.
Refreshing done.
Refreshing.
Defines the type of the module used as interface module 1.
None (communication disabled).
FEN-01.
FEN-11.
FEN-21.
FEN-31.
FSE-31.
Specifies the slot (1...3) on the control unit of the drive into
which the interface module is installed. Alternatively, specifies
the node ID of the slot on an FEA-03 extension adapter.
Slot 1.
Slot 2.
Slot 3.
Node ID of the slot on the FEA-03 extension adapter.
Defines the type of the module used as interface module 2.
None (communication disabled).
FEN-01.
FEN-11.
FEN-21.
FEN-31.
FSE-31.
Specifies the slot (1...3) on the control unit of the drive into
which the interface module is installed. Alternatively, specifies
the node ID of the slot on an FEA-03 extension adapter.
Slot 1.
Slot 2.
Slot 3.
Node ID of the slot on the FEA-03 extension adapter.
Specifies the type of temperature sensor connected to
interface module 1. Note that the module must also be
activated by parameters 91.11...91.12.
None.
PTC. (The unit is ohms.)
Def/FbEq16
Done
0
1
None
0
1
2
3
4
5
Slot 2
1
2
3
1 = 1
None
0
1
2
3
4
5
Slot 3
1
2
3
1 = 1
None
0
1