ABB ACS880 Firmware Manual page 196

196 Parameters
No. Name/Value
Application
Program
ATF
DDCS controller
20.02 Ext1 start trigger
type
Edge
Level
20.03 Ext1 in1 source
Not selected
Selected
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
Other [bit]
20.04 Ext1 in2 source
20.05 Ext1 in3 source
20.06 Ext2 commands
Not selected
In1 Start
ghv Vertriebs-GmbH | Am Schammacher Feld 47 | 85567 Grafing | Telefon + 49 80 92 81 89 0 | info@ghv.de | www.ghv.de
Description
The start and stop commands are taken from the application
program control word (parameter
word).
Note: The start signal is always level-triggered with this
setting regardless of parameter
Reserved.
The start and stop commands are taken from an external
(DDCS) controller.
Note: The start signal is always level-triggered with this
setting regardless of parameter
Defines whether the start signal for external control location
EXT1 is edge-triggered or level-triggered.
Note: This parameter is only effective when parameter
Ext1 commands is set to In1
fwd; In2 Start rev, or Control
The start signal is edge-triggered.
The start signal is level-triggered.
Selects source 1 for parameter
0 (always off).
1 (always on).
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
Digital input/output DIO1 (11.02 DIO delayed
Digital input/output DIO2 (11.02 DIO delayed
Source selection (see Terms and abbreviations
Selects source 2 for parameter
For the available selections, see parameter
source.
Selects source 3 for parameter
For the available selections, see parameter
source.
Selects the source of start, stop and direction commands for
external control location 2 (EXT2).
See also parameters 20.07...20.10.
No start or stop command sources selected.
The source of the start and stop commands is selected by
parameter 20.08 Ext2 in1
source bits are interpreted as follows:
State of source 1 (20.08)
0?1 (20.07 = Edge)
1 (20.07 = Level)
0
06.02 Application control
20.02 Ext1 start trigger
20.02 Ext1 start trigger
Start, In1 Start; In2 Dir,
panel.
20.01 Ext1 commands.
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
status, bit 0).
status, bit 1).
on page 112). -
20.01 Ext1 commands.
20.03 Ext1 in1
20.01 Ext1 commands.
20.03 Ext1 in1
source. The state transitions of the
Command
Start
Stop
Def/FbEq16
21
type.
22
16
type.
Edge
20.01
In1 Start
0
1
DI1
0
1
2
3
4
5
6
7
10
11
DI2
Not selected
Not selected
0
1