ABB ACS880 Firmware Manual page 520

520 Fault tracing
Code
Fault
(hex)
5697 Charging feedback
5698 Unknown power unit
fault
6000 Internal SW error
6181 FPGA version
incompatible
6200 Checksum mismatch
Programmable fault:
Checksum action
6306 FBA A mapping file
6307 FBA B mapping file
6481 Task overload
6487 Stack overflow
64A1 Internal file load
64A2 Internal record load
ghv Vertriebs-GmbH | Am Schammacher Feld 47 | 85567 Grafing | Telefon + 49 80 92 81 89 0 | info@ghv.de | www.ghv.de
Cause
Incorrect parameter setting.
The charging switch and DC
switch were operated out of
sequence, or a start command
was issued before the unit was
ready.
Charging circuit fault.
Brake circuit fault.
Unidentified power unit logic
fault.
Internal error.
Firmware and FPGA file
version in the power unit are
incompatible.
Update of power unit logic
failed.
The calculated parameter
checksum does not match any
96.54
enabled reference checksum.
Fieldbus adapter A mapping
file read error.
Fieldbus adapter B mapping
file read error.
Internal fault.
Internal fault.
File read error.
Internal record load error.
What to do
Check the setting of 95.09 Switch fuse
controller. The parameter should be
enabled only if an xSFC charging
controller is installed.
The normal power-up sequence is:
1. Close charging switch.
2. After charging finishes (charging OK
lamp lights), close DC switch.
3. Open charging switch.
Check the charging circuit.
With a frame R6i/R7i inverter module, the
auxiliary code "FA" indicates that the
charging contactor status feedback does
not match the control signal.
With parallel-connected frame R8i
modules, the auxiliary code (format
XX00), "XX" specifies the affected BCU
control unit channel.
Check the wiring and condition of brake
resistor.
Check power unit logic and firmware
compatibility.
Contact your local ABB representative.
Contact your local ABB representative,
quoting the auxiliary code.
Reboot the control unit (using parameter
96.08 Control board boot) or by cycling
power. If the problem persists, contact
your local ABB representative.
Retry.
See A686 Checksum mismatch
499).
Contact your local ABB representative.
Contact your local ABB representative.
Reboot the control unit (using parameter
96.08 Control board boot) or by cycling
power. If the problem persists, contact
your local ABB representative.
Reboot the control unit (using parameter
96.08 Control board boot) or by cycling
power. If the problem persists, contact
your local ABB representative.
Reboot the control unit (using parameter
96.08 Control board boot) or by cycling
power. If the problem persists, contact
your local ABB representative.
Contact your local ABB representative.
(page