Summary Of Parameter Groups - ABB ACS880 Firmware Manual

Summary of parameter groups

Group
01 Actual values
03 Input references
04 Warnings and faults
05 Diagnostics
06 Control and status words
07 System info
10 Standard DI, RO
11 Standard DIO, FI, FO
12 Standard AI
13 Standard AO
14 I/O extension module 1
15 I/O extension module 2
16 I/O extension module 3
19 Operation mode
20 Start/stop/direction
21 Start/stop mode
22 Speed reference selection
23 Speed reference ramp
24 Speed reference
conditioning
25 Speed control
26 Torque reference chain
28 Frequency reference chain
29 Voltage reference chain
30 Limits
31 Fault functions
32 Supervision
33 Generic timer & counter
35 Motor thermal protection
36 Load analyzer
37 User load curve
40 Process PID set 1
41 Process PID set 2
ghv Vertriebs-GmbH | Am Schammacher Feld 47 | 85567 Grafing | Telefon + 49 80 92 81 89 0 | info@ghv.de | www.ghv.de
Contents
Basic signals for monitoring the drive.
Values of references received from various sources.
Information on warnings and faults that occurred last.
Various run-time-type counters and measurements related to drive
maintenance.
Drive control and status words.
Information on drive hardware, firmware and application program.
Configuration of digital inputs and relay outputs.
Configuration of digital input/outputs and frequency inputs/outputs.
Configuration of standard analog inputs.
Configuration of standard analog outputs.
Configuration of I/O extension module 1.
Configuration of I/O extension module 2.
Configuration of I/O extension module 3.
Selection of local and external control location sources and
operating modes.
Start/stop/direction and run/start/jog enable signal source
selection; positive/negative reference enable signal source
selection.
Start and stop modes; emergency stop mode and signal source
selection; DC magnetization settings; autophasing mode
selection.
Speed reference selection; motor potentiometer settings.
Speed reference ramp settings (programming of the acceleration
and deceleration rates for the drive).
Speed error calculation; speed error window control configuration;
speed error step.
Speed controller settings.
Settings for the torque reference chain.
Settings for the frequency reference chain.
Settings for the DC voltage reference chain.
Drive operation limits.
Configuration of external events; selection of behavior of the drive
upon fault situations.
Configuration of signal supervision functions 1...3.
Configuration of maintenance timers/counters.
Motor thermal protection settings such as temperature
measurement configuration, load curve definition and motor fan
control configuration.
Peak value and amplitude logger settings.
Settings for user load curve.
Parameter values for process PID control.
A second set of parameter values for process PID control.
Parameters 113
Page
115
119
121
127
128
143
146
152
157
161
165
184
188
192
194
203
210
218
224
229
240
246
255
260
268
278
281
289
299
303
306
319