ABB ACS880 Firmware Manual page 416

416 Parameters
No. Name/Value
Other [bit]
96.10 User set status
n/a
Loading
Saving
Faulted
User set 1
User set 2
User set 3
User set 4
96.11 User set save/load
No action
User set I/O mode
Load set 1
Load set 2
Load set 3
Load set 4
Save to set 1
Save to set 2
Save to set 3
Save to set 4
ghv Vertriebs-GmbH | Am Schammacher Feld 47 | 85567 Grafing | Telefon + 49 80 92 81 89 0 | info@ghv.de | www.ghv.de
Description
Source selection (see Terms and abbreviations
Shows the status of the user parameter sets.
This parameter is read-only.
See also section User parameter sets
No user parameter sets have been saved.
A user set is being loaded.
A user set is being saved.
Invalid parameter set.
User set 1 has been loaded.
User set 2 has been loaded.
User set 3 has been loaded.
User set 4 has been loaded.
Enables the saving and restoring of up to four custom sets of
parameter settings. See section
90).
The set that was in use before powering down the drive is in
use after the next power-up.
Notes:
• Hardware configuration settings such as I/O extension
module, fieldbus and encoder configuration parameters
(groups 14...16, 51...56, 58 and 92...93, and parameters
50.01 and 50.31), and forced input/output values (such as
10.03 and 10.04) are not included in user parameter sets.
• Parameter changes made after loading a set are not
automatically stored – they must be saved using this
parameter.
• If no sets have been saved, attempting to load a set will
create all sets from the currently active parameter settings.
Load or save operation complete; normal operation.
Load user parameter set using parameters
mode in1 and 96.13 User set I/O mode
Load user parameter set 1.
Load user parameter set 2.
Load user parameter set 3.
Load user parameter set 4.
Save user parameter set 1.
Save user parameter set 2.
Save user parameter set 3.
Save user parameter set 4.
on page 112). -
(page 90).
User parameter sets (page
96.12 User set I/O
in2.
Def/FbEq16
-
0
1
2
3
4
5
6
7
No action
0
1
2
3
4
5
18
19
20
21