ABB ACS880 Firmware Manual page 195

No. Name/Value
In1P Start; In2 Stop The sources of the start and stop commands are selected by
In1P Start; In2 Stop;
In3 Dir
In1P Start fwd; In2P
Start rev; In3 Stop
Control panel
Fieldbus A
Embedded fieldbus
M/F link
ghv Vertriebs-GmbH | Am Schammacher Feld 47 | 85567 Grafing | Telefon + 49 80 92 81 89 0 | info@ghv.de | www.ghv.de
Description
parameters 20.03 Ext1 in1 source
The state transitions of the source bits are interpreted as
follows:
State of source 1 State of source 2
(20.03)
0?1
Any
Note: The start signal is always edge-triggered with this
setting regardless of parameter
The sources of the start and stop commands are selected by
parameters 20.03 Ext1 in1 source
The source selected by 20.05 Ext1 in3 source
direction. The state transitions of the source bits are
interpreted as follows:
State of State of
source 1 source 2
(20.03) (20.04)
0?1 1
0?1 1
Any 0
Note: The start signal is always edge-triggered with this
setting regardless of parameter
The sources of the start and stop commands are selected by
parameters 20.03 Ext1 in1
20.05 Ext1 in3 source. The state transitions of the source bits
are interpreted as follows:
State of State of
source 1 source 2
(20.03) (20.04)
0?1 Any
Any 0?1
Any Any
Note: The start signal is always edge-triggered with this
setting regardless of parameter
The start and stop commands are taken from the control
panel.
The start and stop commands are taken from fieldbus adapter
A.
Note: The start signal is always level-triggered with this
setting regardless of parameter
The start and stop commands are taken from the embedded
fieldbus interface.
Note: The start signal is always level-triggered with this
setting regardless of parameter
The start and stop commands are taken from another drive
through the master/follower link.
Note: The start signal is always level-triggered with this
setting regardless of parameter
and 20.04 Ext1 in2
Command
(20.04)
1 Start
0 Stop
20.02 Ext1 start trigger
and 20.04 Ext1 in2
determines the
State of
source 3 Command
(20.05)
0 Start forward
1 Start reverse
Any Stop
20.02 Ext1 start trigger
source, 20.04 Ext1 in2 source
State of
source 3 Command
(20.05)
1 Start forward
1 Start reverse
0 Stop
20.02 Ext1 start trigger
20.02 Ext1 start trigger
20.02 Ext1 start trigger
20.02 Ext1 start trigger
Parameters 195
Def/FbEq16
4
source.
type.
5
source.
type.
6
and
type.
11
12
type.
14
type.
15
type.