ABB ACS880 Firmware Manual page 198

198 Parameters
No. Name/Value
In1P Start fwd; In2P
Start rev; In3 Stop
Control panel
Fieldbus A
Embedded fieldbus
M/F link
Application
Program
ATF
DDCS controller
20.07 Ext2 start trigger
type
Edge
Level
20.08 Ext2 in1 source
20.09 Ext2 in2 source
ghv Vertriebs-GmbH | Am Schammacher Feld 47 | 85567 Grafing | Telefon + 49 80 92 81 89 0 | info@ghv.de | www.ghv.de
Description
The sources of the start and stop commands are selected by
parameters 20.08 Ext2 in1
20.10 Ext2 in3 source. The state transitions of the source bits
are interpreted as follows:
State of State of
source 1 source 2
(20.08) (20.09)
0?1 Any
Any 0?1
Any Any
Note: The start signal is always edge-triggered with this
setting regardless of parameter
The start and stop commands are taken from the control
panel.
The start and stop commands are taken from fieldbus adapter
A.
Note: The start signal is always level-triggered with this
setting regardless of parameter
The start and stop commands are taken from the embedded
fieldbus interface.
Note: The start signal is always level-triggered with this
setting regardless of parameter
The start and stop commands are taken from another drive
through the master/follower link.
Note: The start signal is always level-triggered with this
setting regardless of parameter
The start and stop commands are taken from the application
program control word (parameter
word).
Note: The start signal is always level-triggered with this
setting regardless of parameter
Reserved.
The start and stop commands are taken from an external
(DDCS) controller.
Note: The start signal is always level-triggered with this
setting regardless of parameter
Defines whether the start signal for external control location
EXT2 is edge-triggered or level-triggered.
Note: This parameter is only effective when parameter
Ext2 commands is set to In1
fwd; In2 Start rev, or Control
The start signal is edge-triggered.
The start signal is level-triggered.
Selects source 1 for parameter
For the available selections, see parameter
source.
Selects source 2 for parameter
For the available selections, see parameter
source.
source, 20.09 Ext2 in2 source
State of
source 3 Command
(20.10)
1 Start forward
1 Start reverse
0 Stop
20.07 Ext2 start trigger
20.07 Ext2 start trigger
20.07 Ext2 start trigger
20.07 Ext2 start trigger
06.02 Application control
20.07 Ext2 start trigger
20.07 Ext2 start trigger
Start, In1 Start; In2 Dir, In1 Start
panel.
20.06 Ext2 commands.
20.03 Ext1 in1
20.06 Ext2 commands.
20.03 Ext1 in1
Def/FbEq16
6
and
type.
11
12
type.
14
type.
15
type.
21
type.
22
16
type.
Edge
20.06
0
1
Not selected
Not selected