ABB ACS880 Firmware Manual page 114

114 Parameters
Group
43 Brake chopper
44 Mechanical brake control
45 Energy efficiency
46 Monitoring/scaling settings
47 Data storage
49 Panel port communication
50 Fieldbus adapter (FBA)
51 FBA A settings
52 FBA A data in
53 FBA A data out
54 FBA B settings
55 FBA B data in
56 FBA B data out
58 Embedded fieldbus
60 DDCS communication
61 D2D and DDCS transmit
data
62 D2D and DDCS receive
data
90 Feedback selection
91 Encoder module settings
92 Encoder 1 configuration
93 Encoder 2 configuration
94 LSU control
95 HW configuration
96 System
97 Motor control
98 User motor parameters
99 Motor data
200 Safety
206 I/O bus configuration
207 I/O bus service
208 I/O bus diagnostics
209 I/O bus fan identification
ghv Vertriebs-GmbH | Am Schammacher Feld 47 | 85567 Grafing | Telefon + 49 80 92 81 89 0 | info@ghv.de | www.ghv.de
Contents
Settings for the internal brake chopper.
Configuration of mechanical brake control.
Settings for the energy saving calculators.
Speed supervision settings; actual signal filtering; general scaling
settings.
Data storage parameters that can be written to and read from
using other parameters' source and target settings.
Communication settings for the control panel port on the drive.
Fieldbus communication configuration.
Fieldbus adapter A configuration.
Selection of data to be transferred from drive to fieldbus controller
through fieldbus adapter A.
Selection of data to be transferred from fieldbus controller to drive
through fieldbus adapter A.
Fieldbus adapter B configuration.
Selection of data to be transferred from drive to fieldbus controller
through fieldbus adapter B.
Selection of data to be transferred from fieldbus controller to drive
through fieldbus adapter B.
Configuration of the embedded fieldbus (EFB) interface.
DDCS communication configuration.
Defines the data sent to the DDCS link.
Mapping of data received through the DDCS link.
Motor and load feedback configuration.
Configuration of encoder interface modules.
Settings for encoder 1.
Settings for encoder 2.
Control of the supply unit of the drive, such as DC voltage and
reactive power reference.
Various hardware-related settings.
Language selection; access levels; macro selection; parameter
save and restore; control unit reboot; user parameter sets; unit
selection; data logger triggering; parameter checksum calculation;
user lock.
Motor model settings.
Motor values supplied by the user that are used in the motor
model.
Motor configuration settings.
FSO-xx settings.
Distributed I/O bus settings.
Page
321
323
327
330
334
337
339
347
348
349
349
350
351
351
359
372
376
384
393
396
402
402
406
412
424
428
430
436
436