Contents Of The Fieldbus Status Word (Abb Drives Profile) - ABB ACS880 Firmware Manual

568 Fieldbus control through a fieldbus adapter


Contents of the fieldbus Status word (ABB Drives profile)

The upper case boldface text refers to the states shown in the state diagram (page
569).
Bit Name
0 Ready to switch
ON
1 Ready run
2 Ready ref
3 Tripped
4 Off 2 inactive
5 Off 3 inactive
6 Switch-on inhibited 1
7 Warning
8 At setpoint
9 Remote
10 Above limit
11 User bit 0
12 User bit 1
13 User bit 2
14 User bit 3
15 Reserved
ghv Vertriebs-GmbH | Am Schammacher Feld 47 | 85567 Grafing | Telefon + 49 80 92 81 89 0 | info@ghv.de | www.ghv.de
Value STATE/Description
1 READY TO SWITCH ON.
0 NOT READY TO SWITCH ON.
1 READY TO OPERATE.
0 OFF1 ACTIVE.
1 OPERATION ENABLED.
0 OPERATION INHIBITED. See parameters
word and 06.25 Drive inhibit status word 2
1 FAULT.
0 No fault.
1 OFF2 inactive.
0 OFF2 ACTIVE.
1 OFF3 inactive.
0 OFF3 ACTIVE.
SWITCH-ON INHIBITED.
0 –
1 Warning active.
0 No warning active.
1 OPERATING. Actual value equals reference = is within tolerance
limits (see parameters 46.21...46.23).
0 Actual value differs from reference = is outside tolerance limits.
1 Drive control location: REMOTE (EXT1 or EXT2).
0 Drive control location: LOCAL.
- See parameter 06.29 MSW bit 10
- See parameter 06.30 MSW bit 11
- See parameter 06.31 MSW bit 12
- See parameter 06.32 MSW bit 13
- See parameter 06.33 MSW bit 14
06.18 Start inhibit status
for the inhibiting condition.
sel.
sel.
sel.
sel.
sel.