Parameter Groups 01 - ABB ACL30 User Manual

Parameter groups 01...09

No. Bit/Name/Value/
Range
01
01 ACTUAL
VALUES
01.01 SPEED ACT
-30000.00...
30000.00 rpm
01.02 SPEED ACT PERC
-1000.00...
1000.00%
01.03 FREQUENCY
-30000.00...
30000.00 Hz
01.04 CURRENT
0.00...30000.00 A
01.05 CURRENT PERC
0.0...1000.0%
01.06 TORQUE
-1600.0...1600.0%
01.07 DC-VOLTAGE
0.00...2000.00
01.08 ENCODER SPEED
-32768.00...
32768.00 rpm
01.09 ENCODER POS
0.00000000...
1.00000000 rev
Description
Basic signals for monitoring the drive.
All signals in this group are read-only, unless
otherwise specified.
Shows the filtered actual speed.
Used speed feedback is defined by parameter
22.01 SPEED FB SEL. Filter time constant can be
adjusted by parameter
Actual speed in rpm.
Shows the actual speed in percent of motor
synchronous speed.
Actual speed in percent.
Shows the estimated drive output frequency.
Output frequency in Hz.
Shows the measured motor current.
Motor current in A.
Shows the motor current in percent of nominal motor
current.
Motor current in percent
Shows motor torque in percent of motor nominal
torque.
Motor torque in percent
Shows the measured intermediate circuit voltage.
Intermediate circuit voltage
Shows the encoder speed.
Encoder speed in rpm.
Shows the actual position of encoder within one
revolution.
Encoder position within one revolution.
22.02 SPEED ACT FTIME.
Parameters 185
Def/Type
FbEq
(16b/32b)
- / Real
- /
100 = 1 rpm
- / Real
- / 100 = 1%
- / Real
- /
100 = 1 Hz
- / Real
- / 100 = 1 A
- / Real
10 = 1%/ -
- / Real
10 = 1%/ -
- / Real
- /
100 = 1 V
- / Real
- /
100 = 1 rpm
- / Real24
- /
100000000
= 1 rev