Summary Of Parameter Groups - ABB ACQ80-04 Firmware Manual

Summary of parameter groups

Group
01 Actual values
03 Input references
04 Warnings and faults
05 Diagnostics
06 Control and status words
07 System info
10 Standard DI, RO
11 Standard DIO, FI, FO
12 Standard AI
13 Standard AO
21 Start/stop mode
23 Speed reference ramp
24 Speed reference
conditioning
25 Speed control
28 Frequency reference chain
30 Limits
31 Fault functions
32 Supervision
35 Motor thermal protection
36 Load analyzer
40 Process PID set 1
46 Monitoring/scaling settings
49 Panel port communication
50 Fieldbus adapter (FBA)
51 FBA A settings
52 FBA A data in
53 FBA A data out
58 Embedded fieldbus
79 Start stop control
80 Flow calculation
82 Pump protections
83 Pump cleaning
95 HW configuration
Contents
Basic signals for monitoring the drive.
Values of references received from various sources.
Information on warnings and faults that occurred last.
Various run-time-type counters and measurements related to drive
maintenance.
Drive control and status words.
Drive hardware and firmware information.
Configuration of digital inputs and relay outputs.
Configuration of the frequency input.
Configuration of standard analog inputs.
Configuration of standard analog outputs.
Start and stop modes.
Speed reference ramp settings (programming of the acceleration
and deceleration rates for the drive).
Speed error calculation; speed error window control configuration;
speed error step.
Speed controller settings.
Settings for the frequency reference chain.
Drive operation limits.
Configuration of external events; selection of behavior of the drive
upon fault situations.
Configuration of signal supervision functions 1...6.
Motor thermal protection settings such as temperature
measurement configuration, load curve definition and motor fan
control configuration.
Peak value and amplitude logger settings.
Parameter values for process PID control.
Speed supervision settings; actual signal filtering; general scaling
settings.
Communication settings for the control panel port on the drive.
Fieldbus communication configuration.
Fieldbus adapter A configuration.
Selection of data to be transferred from drive to fieldbus controller
through fieldbus adapter A.
Selection of data to be transferred from fieldbus controller to drive
through fieldbus adapter A.
Configuration of the embedded fieldbus (EFB) interface.
Start - stop control configuration parameters.
Defines flow calculation parameters.
Settings for dry run protection.
Settings for the pump cleaning sequence.
Various hardware-related settings.
Parameters 65
Page
67
70
71
71
74
77
78
82
84
88
93
96
97
97
101
102
106
114
120
127
130
140
142
143
146
147
148
148
155
162