Summary Of Parameter Groups - ABB ACS880 Firmware Manual

46 Parameters

Summary of parameter groups

Group
101 Actual values
102 Actual values
103 Input references
104 Warnings and faults
105 Diagnostics
106 Control and status words
107 System info
110 Standard DI, RO
111 Standard DIO, FI, FO
112 Standard AI
113 Standard AO
114 Extension I/O module 1
115 Extension I/O module 2
116 Extension I/O module 3
119 Operation mode
120 Start/stop
121 Start/stop mode
122 Power reference
123 DC voltage reference
128 DC voltage controller
129 Current controller
130 Limits
131 Fault functions
133 Generic timer & counter
136 Load analyzer
146 Monitoring settings
147 Data storage
149 Panel port communication
150 FBA
151 FBA A settings
152 FBA A data in
153 FBA A data out
154 FBA B settings
155 FBA B data in
156 FBA B data out
160 DDCS communication
161 DDCS transmit
162 DDCS receive
191 BAMU configuration
192 Additional actual values 2
Contents
Basic signals for monitoring of the DC/DC converter unit.
Basic signals for monitoring of the DC/DC converter used by the
converter control.
Values of references received from various sources.
Information on warnings and faults that occurred last.
Various run-time-type counters and measurements related to
DC/DC converter unit maintenance.
Control and status words.
Hardware and firmware information.
Status and configuration of digital inputs and relay outputs.
Configuration of digital input/outputs and frequency inputs/outputs.
Configuration of analog inputs.
Configuration of analog outputs.
Configuration of I/O extension module 1.
Configuration of I/O extension module 2.
Configuration of I/O extension module 3.
Selection of external control location sources.
Start/stop, run/enable and start enable signal source selection.
Emergency stop mode and signal source selection.
Settings and signals for the power reference chain.
Settings and signals for the DC voltage reference chain.
Settings and signals for the DC voltage controller.
Settings and signals of the current controller.
Converter operation limits.
Settings that define the behavior of the DC/DC converter unit upon
fault situations.
Configuration of maintenance timers/counters.
Peak value and amplitude logger settings.
Scaling settings.
Parameters that can be written to and read from by using source
and target settings of other parameters.
Communication settings for the control panel port on the DC/DC
converter unit.
General settings for fieldbus communication configuration.
Fieldbus adapter A configuration.
Selection of data to be transferred from DC/DC converter unit to
fieldbus controller through fieldbus adapter A.
Selection of data to be transferred from fieldbus controller to the
DC/DC converter unit through fieldbus adapter A.
Fieldbus adapter B configuration.
Selection of data to be transferred from the DC/DC converter unit
to fieldbus controller through fieldbus adapter B.
Selection of data to be transferred from fieldbus controller to the
DC/DC converter unit through fieldbus adapter B.
DDCS communication configuration.
Defines the data sent to the DDCS link.
Mapping of data received through the DDCS link.
Configuration of the measuring board (BAMU-1x).
Actual values for the additional phases of the 6-phase modulator.
Page
48
49
50
50
51
52
57
57
62
65
68
71
87
90
94
94
97
97
98
100
102
102
107
114
119
122
122
123
124
129
130
130
131
132
132
133
134
138
141
141