Using The Gr25/50 Internal Battery And Charger; Charging; Working With The Memory Device - Leica GR30 Online Help Manual

Step Description
The battery is inserted in the front of the instrument.
Loosen the screws on the battery compartment with the Allen key provided with the GR25/50.
1
Remove the battery cover.
2
With the arrow facing forward, slide the battery into the battery compartment and push so that it locks into
3
position.
Replace the cover of the battery compartment and tighten the screws.
4
To remove the battery, loosen the screws and remove the cover of the battery compartment.
5
Push the ledge on the right side of the battery compartment to the right until it releases the battery.
6
Pull out the battery.
7
Replace the cover of the battery compartment and tighten the screws.
8

Using the GR25/50 Internal Battery and Charger

Charging

•
Battery charging can be enabled in the GR25/50 Web Interface. Go to Receiver setup / Power management.
Note: When charging the GEB241 battery with the internal charger, it is technically possible to charge the GEB241 battery
between 0°C to +65°C/ +32°F to +149°F. Please note the internal temperature reading on the GR25/50 web interface
•
When the receiver is turned on, the battery charging status is indicated in the GR25/50 Web Interface.
•
When the receiver is powered down, battery charging is indicated via the LEDs. For further information refer to LED Indicators
on the GR25/50.

Working with the Memory Device

Working with the Memory Device
•
Keep the card dry.
•
Use it only within the specified temperature range.
•
Do not bend the card.
•
Protect the card from direct impacts.
5: Getting started
53