Related Topics; How To Configure Ftp Push Of Logged Data; Background Information - Leica GR30 Online Help Manual

Go to the GNSS management / Data streams.
2
Open the Incoming data streams tab.
3
4
Press the Create new data stream
5
Select the Real time in the Data stream type list. Then press the Continue
On the Configure real time data stream page
6
•
Select the RTK data format to be received.
•
Select the manufacturer of the Reference Sensor the real time correction data is to be received
from. This is important when using a reference station receiver from a different manufacturer, as it
allows the correct application of GLONASS inter frequency biases. If the Sensor type is not know,
this field can be left blank. Some real time formats transmit the receiver type.
•
Select the antenna type of the Reference antenna so the phase centre corrections can be applied
correctly. If the antenna type is not known, this field can be left blank. Some real time formats
transmit the antenna type.
•
If network corrections are received, select the type of RTK network corrections to be received so
ionospheric and tropospheric modelling will be used for position calculation accordingly.
•
Enable the sending of NMEA GPUID authentication details if necessary for user authentication with
the RTK correction provider. If the field is activated, enter the users' IDs. User ID 1 must be
entered when the check box is enabled. User ID 2 is optional.
•
Select the Position type to be calculated depending on the planned application. Please see
Configured an incoming data stream for a description of the different position types.
Then press the Continue
7
Select the Connection type, Ntrip client in the Connection page and press the Continue
On the Configure NTRIP client page
8
•
For Ntrip caster IP address enter the IP address of the Ntrip caster to receive data from.
•
In the TCP/IP port field enter the port at which the Ntrip client can access the mount point.
•
Enter the Mount point name manually or press the
will fill the Source table list with all mount points available on the configured Ntrip caster. Select a
mount point from that list.
•
Enter the User name and Password required for client authentication on the mount point. If the
mount point does not require authentication, these fields can be left blank.
Then press the Continue
9
Press the Save
caster immediately. Check the event log for a confirmation that the connection was successful.

Related Topics

Glossary: Ntrip
Ntrip caster: Overview
Outgoing data streams wizard: Configure Ntrip server (source)
Incoming data streams wizard: Configure Ntrip client

How to configure FTP push of logged data

Background information

212
to open the data streams wizard.
icon.
icon.
button to store the data stream. The receiver will attempt a connection to the Ntrip
icon.
Get source table link. Pressing the link
icon.