11: External Devices
External Devices: Overview
This section explains which external devices can be used with the instrument.
Portable browsers
•
Leica surveying controllers CS10 and CS15
•
Other web enabled devices
Besides the CS10 and CS15 any other device that comes with a web browser and a USB host or Bluetooth connector can be
used to configure the instrument. Follow the procedure as describes above for the CS10 and CS15. If no Internet Explorer but
another web browser is available on the portable device use this other web browser instead.
Communication devices
•
Working with Radio, Modem and GSM devices: Overview
•
Serial devices connected to a GFU housing
•
Devices fitting into a GFU housing
•
Connecting a GFU device
•
Insert and remove a SIM card step-by step for an external GFU device
•
LED indicators
•
Slot-in devices
•
Devices fitting into the instruments Slot in (P3)
•
Insert and remove a slot-in-device step-by-step
•
Insert and remove a SIM card step-by-step
•
LED indicators
Routers, switches and hubs
Within a local network the GR/GM receiver has to be connected to some kind of network device. This may be a router, a switch or a hub
providing a bandwidth of 10 or 100 MBit. Use a standard Ethernet cable with RJ45 connector and connect the one end with the RJ45
connector of the instrument. Then connect the other end with a RJ45 connector of the network device. As a result the instrument is
physically connected to the local network.
Please refer to section "Getting Started" to find more details on how the instrument can be configured to allow access via TCP/IP
protocol and how the web interface can be accessed.
Meteorological sensors
223