Incoming Data Stream Wizard: Select Data Stream; Setting Descriptions; Incoming Data Stream Wizard: Configure Meteo; Background Information - Leica GR30 Online Help Manual

MET RINEX Observational Types

Incoming data stream wizard: Select data stream

Setting Descriptions

The table below describes the settings that can be configured on the Select data stream page.
Setting Description
Select the incoming data stream type.
Data stream
type
•
•
•
Press to continue to the next wizard step.
Press to cancel and return to GNSS management: Incoming data streams.

Incoming data stream wizard: Configure Meteo

Background Information

Meteorological sensors are used for measuring air pressure, temperature and relative humidity. The data from the meteo sensor is
logged together with the GPS raw observations into the MDB and RINEX files. If RINEX logging is active, an additional meteo RINEX
file is created that contains the data from the meteo sensor.
Data is logged into the same file as the GPS raw observations (MDB) or into a file with the same file name but with the extension m
(RINEX). No data is logged, unless raw observation logging is configured and a logging session is started.
Setting Descriptions
The table below describes the settings that can be configured on the Configure Meteo device page.
Setting
Device
Data rate
Connected to
Temperature
Pressure
Relative Humidity
Wind azimuth
Wind speed
Rain Increment
Hail indicator
106
Meteo
Tilt
Real time
Description
Select from the list box all available meteo sensors available on the receiver.
Select the rate at which data is requested from the meteo sensor.
Only available on the GR25/50.
Select the physical serial port for data transmission
•
Serial port 1
•
Serial port 2
For the GR10/30 & GM10/30, Serial port 1 is configured
automatically as there is only one serial port available.
Select to display and log the dry temperature in degrees Celsius.
Select to display and log the pressure in mbar.
Select to display and log the relative humidity as a percentage.
Select to display and log the wind azimuth (deg) from the direction that the wind blows.
Select to display and log the wind speed in meters per second (m/s).
Select to display and log the rain accumulation since last measurement (mm).
Select to display and log the hail detected since last measurement in hits per square
centimetre.