Setting Descriptions - Leica GR30 Online Help Manual

This page provides an overview of the configured outgoing data streams.
Configure outgoing real time, LB2 (Leica Binary), NMEA or BINEX messages from the receiver by pressing Create new data stream
.
The maximum number of configured outgoing data streams is 22, 20 TCP/IP connections and 2 serial
connection available.
Mozilla Firefox does not support the use of certain ports. Use a different internet browser if these ports need
to be used. Ports blocked by default in Mozilla Firefox browser.

Setting Descriptions

The table below describes the fields in the Outgoing data streams tab.
Setting
Icon
Stream Type
Type/Message
Connection
Device
Port
Delete
Edit data stream
Create new data stream
(copy)
Activate
Create new data
stream
After installing the dual frequency option, the configured data streams must be restarted to enable both L1
92
Description
Data stream is active.
Data stream is inactive.
To activate or deactivate a data stream press the Activate icon.
The configured outgoing data type.
The configured outgoing message types.
The configured connection type.
The configured device used for transmitting the outgoing data stream.
The configured port on the receiver used for transmitting the outgoing
data stream.
Press delete to permanently delete the data stream.
Press to edit the data stream settings. The outgoing data stream wizard
will open.
Press to create a new data stream product based on the settings of an
existing data stream.
The data stream is inactive. Click to start streaming
data.
The data stream is active. Click to stop streaming
data.
Upon pressing Create a new data stream, the Data stream wizard
opens.
The wizard is a tool that guides you through the following stages of an
outgoing data stream configuration:
•
Streamed data types - real time, LB2 (Leica Binary), NMEA or
BINEX
•
Message selection
•
Connection type and configuration
•
Activating the data stream