Related Topics; Receiver Setup: Option Management; Background Information; Setting Descriptions - Leica GR30 Online Help Manual

Install automatically
Install
Valid DNS server settings are required for the automatic firmware notification and download.

Related topics

Receiver setup: File upload

Receiver setup: Option management

Background Information

The Option management page allows the installation and deletion of options, and provides an overview of all purchased options that are
currently installed on the receiver.

Setting Descriptions

The table below describes the information that is contained in the Options tab.
190
•
Leica Geosystems - our Leica Geosystems web server where new
firmware files are available at release. Note: the file download will
only be done if a valid maintenance option is installed on the
receiver.
•
A user defined FTP location - All FTP locations created at GNSS
management - FTP and USB locations can be selected. The user
must load the new firmware file to this location to allow automatic
download to the receiver's SD card.
The receiver will check every 24 h if a new firmware file s available for
download.
Activate to install a new firmware file automatically at the time specified at
Install.
A new firmware file is only installed if:
•
the firmware file is available on the receiver's SD card,
•
the installed maintenance option is valid,
•
the firmware file type matches the receiver type,
•
the firmware file has a higher version than the already installed
firmware.
Select the time at which the new firmware file is to be installed. There are
three options for the installation timing:
•
after automatic download. Only available when the automatic
download of the firmware to the SD card was done automatically.
As soon as the download is finished, the firmware file installation is
started.
•
On the day the firmware is found on the SD card, at a specified
time: Select "same day" and set a time for the firmware installation.
The receiver will install the firmware on the day it was detected on
the SD card, at the time specified. If this time has passed when the
file was found, the firmware will be installed the next day at that
time.
•
On a specified weekday at a specified time: Select the day of the
week and the time for firmware installations, e.g. Sunday at 0:00.
After the receiver has detected a new firmware file on the SD card,
it will wait for the configured day and time of the week and then
install the firmware file.