Related Topics; Gnss Management: Tracking; Gnss Management: Tracking General; Background Information - Leica GR30 Online Help Manual

Restore default
values

Related Topics

Status: Position
Configure coordinates and site name step-by-step

GNSS management: Tracking

GNSS management: Tracking General

Background information

If an external oscillator is selected but not connected, the receiver will not track any satellite signals.
If an external oscillator is selected but not connected and the fallback option is activated, the internal clock
will be used.
Changing the Satellite system, Satellite signals and/or Cut-off angle interrupts logging and streaming. If any
of these settings are changed while a logging session is active, the current file will be finalized and a new
file will start to be logged.
GPS and GLO L2C cannot be activated while an incoming real time data stream is activated for fixed
position calculation.
If you want to enable GPS and GLO L2C tracking make sure to first disable the incoming real time data
stream.
Exclusive GPS L2C tracking is not possible. This means that enabling GPS L2C only, but not GPS L2P(Y),
will implicitly activate L2P(Y) data to be tracked on satellites that do not provide L2C.
If L2P(Y) and L2C is enabled, L2P(Y) will be tracked for all GPS satellites and L2C where available.

Setting Descriptions

The table below describes the settings that can be configured on the Tracking General tab.
Satellite system
84
reference station, the reference station should not be used for relative positioning.
A position adjustment is necessary to calculate the exact coordinate for the
reference position. The current position helps to set up reference station
receivers to collect data for this position adjustment.
The Save button
Press to restore the default values.
The restore default button fills all fields with the
default values and stores these values. Pressing the
save button is not necessary. When accepting the
confirmation message, all settings on this page are
overwritten with the default settings.
Description
Activate the satellite system(s) to be tracked.
must be pressed to store the current position.