Outgoing Data Stream Wizard: Connection; Background Information; Setting Descriptions - Leica GR30 Online Help Manual

The data rates may be specified for each of the following messages:
Message
•
•
•
•
•
The following sub messages are sent out:
Sub message
•
•
•
•
•
Select the data rate for the BINEX messages.
Rate
When new data available: The receiver will send the message whenever new data is available.
e.g. whenever the receiver receives new ephemeris data for a certain satellite. This option is only
available for BINEX 0x01 GNSS Navigation Information output control.
Press to go back to the previous wizard step. Press
Press to cancel and return to GNSS management: Outgoing data stream.

Outgoing data stream wizard: Connection

Background Information

Data can be streamed from the receiver using a variety of communication types.

Setting Descriptions

The table below describes the settings that can be configured on the Connection page.
Setting Description
Select the connection type.
Connection type
TCP/IP server
TCP/IP client
98
Meta data (0x00)
Navigation data (0x01)
Internal state (0x7D)
Ancillary site data (0x7E)
Observation data (0x7F)
Meta data (0x00):
Navigation data (0x01:)
Internal state (0x7D):
Ancillary site data (0x7E):
Observation data (0x7F:)
Message 7F-05 must be used in order to stream BeiDou and/or QZSS
observations.
The receiver works as a TCP server allowing TCP
clients to connect to the receiver's ports to receive
the data streams.
This setting allows the receiver to act as a TCP client
none
0x01: decoded GPS ephemeris
0x02: decoded GLONASS ephemeris
0x03: decoded SBAS ephemeris
0x04 decoded GALILEO ephemeris
0x00
0x00
0x05 and 0x04 or 0x03 and 0x04
to continue to the next wizard step.