How To: Overview; How To Set Up A Mobile Internet Connection; Background Information; Before You Begin - Leica GR30 Online Help Manual

9: How to

How to: Overview

The following topics provide detailed step-by-step guides to help you configure your receiver:
•

How to set up a mobile internet connection

•
How to use DynDNS service on receiver
•
How to backup and restore receiver settings
•
How to configure an NTRIP data stream
•
How to configure FTP push of logged data
•
How to reset the receivers settings
•
How to configure a Wake-up session
•
How to use Bluetooth on the GR25
How to set up a mobile Internet connection

Background information

The mobile Internet setup is used to connect a GR/GM receiver to the Internet when no direct LAN connection is possible. A GPRS
enabled device is necessary to establish this connection.

Before you begin

In order to connect to the Internet from a GR/GM receiver, it is necessary to apply for an APN (access point name) at your Internet
service provider.
Together with the APN, a profile must be assigned to you. This profile is a list of all ports that are open and available for use. It needs to
be activated for each SIM card you want to use for a mobile Internet connection.
When using Email and FTP push, make sure that the relevant SMTP and FTP ports are open. For DynDNS service, either port 80, 8245
or 443 also have to be available. The profile also needs to contain the IP of at least one DNS server that is run by your provider if you
want to use DynDNS

Step-by-step

Step Description
Connect a GPRS device to the serial or slot-in port of the receiver.
1
For more information how to connect a device go to External devices / Working with Radio, Modem and
GSM devices / Slot-in devices.
Open the receiver's web interface. Check that the event log states that the GPRS device has been detected.
2
Go to Receiver setup / Network connections. Open the mobile Internet tab.
3
Select the GPRS device from the drop down list. If the used device is not available in the list, open Device
4
management to create a new, user defined device. For more information on creating a new device see
Device Management: New / Edit modem/phone device.
Enter the PIN code of the used SIM card. If the SIM card PIN is disabled, this field can be left blank.
5
Enter the APN, the user name and the password.
6
If a dynamic IP address is used, leave the IP address field set to dynamic. If you have a static IP address,
7
207