Related Topics; Receiver Setup: Power Management; Background Information; Setting Descriptions - Leica GR30 Online Help Manual

Hide thumbs Also See for GR30:
Table of Contents

Advertisement

Autodelete event log entries
Event log emailing
Enable event email
Send event email to
Email address of sender
Mail server name (SMTP)
Mail server port
Mail server username
Mail server password
Send event email every
Save changes
Send test email
Restore default values
Clear complete event log
Please note that verbose messages are not included in Event emails. Go to Status / Event log, adjust the
filter settings to include verbose messages and use the download button in order to have all messages,
including the verbose messages. This procedure should be applied before contacting support.
Verbose mode will be deactivated after closing the browser, logging out of the receiver, or rebooting the
receiver.

Related topics

Status: Event log

Receiver setup: Power management

Background Information

Configure the power up and low power behaviour of the receiver according to the intended use case.

Setting Descriptions

The table below describes the settings that can be configured on the Power management page.
Select the time interval after which event log messages are deleted from the
receivers data base.
Description
Activate to send the content of the event log via email.
When activated the Event log emailing settings are visible and can be edited.
Enter a single email address or a list of email addresses (separated by semicolon
";") to send the event log to.
Enter the email address to be displayed as the sender when emailing the event
log.
Enter the IP address or the domain name of the SMTP server to be used.
Enter the TCP port number of the SMTP server (commonly used defaults: 25 or
587).
Enter the username as configured for the SMTP server account.
Enter the password as configured for the SMTP server account.
Select the interval to send event email.
The email interval will be aligned with midnight UTC time. This means for
example, if you select a time interval of 6hrs and your local UTC time is +2hrs,
event emails will be sent at 8am, 2pm, etc...
Press to store all event log and email settings.
Press to send a test email using the entered settings. Check the event log for
results.
Press to fill the form with factory default settings.
The restore default button fills all fields with the default
values and stores these values. Pressing the save button
is not necessary. When accepting the confirmation
message, all settings on this page are overwritten with
the default settings.
Press to permanently remove all entries from the event log. This cannot be
undone!
6: Context sensitive help
181

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gr50Gm30

Table of Contents