Outgoing Data Stream Wizard: Configure Tcp/Ip Client; Background Information; Setting Descriptions; Outgoing Data Stream Wizard: Configure Ntrip Server (Source) - Leica GR30 Online Help Manual

Press to cancel and return to GNSS management: Outgoing data stream.

Outgoing data stream wizard: Configure TCP/IP client

Background Information

The TCP/IP client connection setting allows the receiver to act as a TCP client and send data out to a configured IP address and port.
This way no port has to be opened in the firewall to allow clients to connect to the receiver. Furthermore since the data stream is now
sent to a PC port, the number of connections to the data stream is not limited by the receiver.

Setting Descriptions

The table below describes the settings that can be configured on the Configure TCP/IP client page.
Setting
Server IP address
TCP/IP port
Press to go back to the previous wizard step. Press
Press to cancel and return to GNSS management: Outgoing data stream.

Outgoing data stream wizard: Configure Ntrip server (source)

Background Information
This mode allows the receiver to act as Ntrip Server, and to provide data to an Ntrip Caster.
In terms of TCP/IP, the Ntrip server mode is in fact a TCP client mode. As an Ntrip Server, the receiver connects to a caster and starts
to stream data.
Setting Descriptions
The table below describes the settings that can be configured on the Configure Ntrip server (source) page.
Setting
Use local caster
Ntrip caster IP address
TCP/IP port
Mount point
Choose mount point
100
Description
Enter the numeric IP address of the Server to connect to.
The valid IP range is from 1.0.0.0 to 223.255.255.255.
Enter the TCP/IP port of the receiver.
Description
If the Ntrip caster on this receiver is active and mount points are defined, a data stream can
be sent directly to this caster and distributed to Ntrip clients.
Activating this check box will automatically set the correct settings for the local caster and
provide a list of all the available mount points on the local Ntrip caster.
The hostname or IP address of the Ntrip caster to connect to.
The valid IP range is from 1.0.0.0 to 223.255.255.255.
Enter the TCP/IP port to connect to on the Ntrip caster.
Enter the mount point.
The mount point is the identifier of a data stream on an Ntrip Caster. It is needed to provide
data to an Ntrip Caster.
Only available when "Use local caster" is activated. It shows a list of all the mount points
configured on the local Ntrip caster. A mount point can be selected and will then appear in
the mount point field. The mount point name can be edited later.
It is possible to enter a mount point name that is not yet defined on the local Ntrip caster.
Store the data stream and define the mount point afterwards.
to continue to the next wizard step.