Setting Descriptions - Leica GR30 Online Help Manual

1. The receiver starts logging at 15:00h because the first interval starts.
2. The receiver stops logging and closes the file at 15:30h because the first interval ends.
3. The receiver starts logging into a new file at 15:40h because the second interval starts.
4. The receiver closes this file at 15:59:59h and immediately starts a new file because of the 1h file rollover.
5. The receiver stops logging and closes this file at 16:10h because the second interval ends.

Setting Descriptions

The table below describes the settings that can be configured on the Session timing page.
Please note that the time settings will refer to the receivers defined Time zone. To set the receivers Time zone, go to GNSS
management / Site name and coordinates.
Setting
Start logging at
End logging
No. of intervals
Start next session
Create a wake up session
Description
Configure the start time and date of the logging session.
Use the date and time pickers to select the logging start time.
Configure the end time and date or the duration of the logging session.
End logging
•
at: Select a time and date for the first logging interval to end.
•
after: Select a time interval after which the first logging interval ends.
•
no end: The logging session starts at the defined date and time, and
runs continuously.
The minimum time interval for a logging session to run is 5 minutes.
Configure the number of repeats for the current logging session.
This setting is only available if End logging is set to at or after.
Select
•
Select run to enter a number of repetitions for this logging session.
•
Select repeat infinitely to configure a logging session with no defined
end.
•
Select run once to configure only one interval for a logging session.
This setting is only active if repeat infinitely or run is selected in the No. of
repeats.
Configure the time for the next session to start as the number of days, hours and
minutes after the last session ended.
Note: The gap between logging sessions only has an impact if it is repeated at
least once. The length of the gap must not be more than 20 days 23:55 h.
Activate to create a wake-up session with the same timing settings as this logging
session.
When the check box is activated and the logging session is stored, a wake-up
session with the same name is created. This wake-up session has the same time
and repeat settings as the logging session.
After the logging session is stored and the wake-up session is created, both can
be edited and deleted independently. The logging session will continue to run
without the wake-up session if the receiver is turned on. The wake-up session will
run without the logging session if the logging session was deactivated.
6: Context sensitive help
123