Related Topics; Remote Access Wizard: Connection; Setting Descriptions - Leica GR30 Online Help Manual

Press to create a new remote access configuration based on the existing configuration.
Create new
Spider and remote
port (copy)
Activate
Click to open the Spider/remote access wizard.
Create new Spider
and remote port
The wizard is a tool that guides you through the following stages of a remote access
configuration:
1.
2.
3.

Related topics

Remote access wizard: Connection

Remote access wizard: Configure TCP/IP server
Remote access wizard: Configure TCP/IP client
Remote access wizard: Configure Ntrip server (source)
Remote access wizard: Configure Serial port
Remote access wizard: Configure Radio
Remote access wizard: Configure GSM / Modem / CDMA-dial up
Remote access wizard: Set port status
Remote access wizard: Connection

Setting Descriptions

The table below describes the settings that can be configured on the Connection page.
Setting Description
Select the connection type that is needed for Leica GNSS Spider or other OWI based software
Connection type
to connect to the receiver.
TCP/IP server
TCP/IP client
Ntrip server (source)
160
The remote access is deactivated. Click to activate the stream.
The remote access is activated. Click to deactivate the stream.
Connection type - Select if you want to connect the GR/GM receiver to the
Spider site server via TCP/IP server, TCP/IP client, Ntrip server (source),
Serial port, Radio or GSM / Modem / CDMA - dial up.
Device selection and configuration.
Activation of remote access.
This setting allows the receiver to works as a TCP
server, allowing TCP clients to connect to the
receiver's NET ports.
This setting allows the receiver to act as a TCP client
and connect to a configured IP address and port.
This way no port has to be opened in the firewall on
the receiver side to allow clients to connect to it.
This setting allows the receiver to act as an Ntrip
source and connect to a configured Ntrip caster IP