Table of Contents
Advertisement
Flow control
Press
to go back to the previous wizard step. Press
Press
to cancel and return to Spider and remote access: Overview .
Remote access wizard: Configure Radio
Background Information
Radios can be used to connect the receiver to Leica GNSS Spider or other OWI based software, if the radios are configured for two-way
communication.
The radio on the Leica GNSS Spider side must be pre-configured in a way that it can be addressed as serial device.
Go to Receiver Setup / Device Management page to change the communication settings of a device if needed.
Setting Descriptions
The table below describes the settings that can be configured on the Configure Radio page.
Setting
Device
Channel
Connected to
Press
to go back to the previous wizard step. Press
Press
to cancel and return to Spider and remote access: Overview .
Remote access wizard: Configure GSM / Modem / CDMA
Background Information
The settings on this page allow Leica GNSS Spider or other OWI based software to use a modem to dial into a modem connected to the
GR/GM receiver and configure the receiver.
164
Defines which kind of handshake is used.
•
None: No handshake.
•
RTS/CTS: Handshake in both directions.
Description
Select the radio device.
The radio channel can only be changed if the radio is attached. If the configured radio device
is not attached, the device will be stored with the default channel 1 (or the last stored
channel when the device was attached) and a message is displayed in the event log.
Only available on the GR25/50.
Select the physical serial port for data transmission
•
Serial port 1
•
Serial port 2
For the GR10/30 & GM10/30, Serial port 1 is configured
automatically as there is only one serial port available.
For slot in devices, this field is not available, the slot-in port is
selected automatically.
to continue to the next wizard step.
to continue to the next wizard step.
- Quick Links:
- Operation by Web Interface
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
