Setting Descriptions - Leica GR30 Online Help Manual

Setting Descriptions

The table below describes the settings that can be configured on the WLAN page.
Wireless radio
Profile name
SSID
Select wireless network
Network infrastructure
Network authentication
Encryption type
Network key
IP settings
Obtain an IP address
automatically
IP address
150
Description
Define a unique name for the wireless profile.
Enter the Service set ID of the network you want to connect to or define the SSID of your
own network, when creating an ad hoc connection. Can be left blank when the Select
wireless network field below is used.
Press Find wireless network to start a search for available wireless networks. Then
select a network to connect to from the drop down list. The SSID field will be updated to
show the selected network.
Select the network type for the new profile.
Infrastructure: Connect the GR25/50 to a network with wireless access point.
Ad hoc: Create a direct wireless connection to one other device without an access point.
For Ad hoc connections please note that some devices can
not resolve the hostname when no DNS server is available.
To make sure that the web interface can be accessed use
an Ad hoc connection with a static IP address for the
GR25/50, e.g. the default Ad hoc profile.
For more information on using the default Ad hoc profile
see How to use WLAN on the GR25/50
Select the method to be used for device authentication in the network to connect to or
define the authentication type for the new ad hoc connection.
Select the method for encryption used in the network to connect to or define the
encryption type for the new ad hoc connection.
Enter the network encryption key if necessary. A key is always needed unless the
encryption type is set to "Disabled".
Handling encryption in ad hoc mode:
In case different network keys have been entered on the
GR25/50 and a Windows PC when using an ad-hoc
connection, both sides will falsely report that the connection
has been established. However, access to the web
interface and data streaming will not be possible. In this
case, double-check the security settings and the encryption
key on both sides.
Description
Activate to obtain the IP address automatically using DHCP.
For more information on how to access the web interface in
a non-DHCP network, please refer to Setup in a non -
DHCP network.
Enter the Internet protocol address of the receiver.
This field can only be edited if the Obtain an IP address automatically field is
disabled.
The IP address is a 32 bit number which must be obtained from the network
administrator or the Internet service provider. The format of the IP address is
aaa.bbb.ccc.ddd where aaa is a value ranging from 001 to 223 and bbb, ccc and ddd