Setup Via Web Interface Over Wlan (Gr25/50) - Leica GR30 Online Help Manual

Step Description
1 Turn on the receiver.
2 Use the arrow buttons, go to Configuration, Network Config. Scroll down to the Bluetooth field and use the
left button to enable Bluetooth.
3 Activate bluetooth on your computer and search for Bluetooth devices. The instruments hostname will be
listed.
4 Pair the Bluetooth connection of your computer with the instrument.
The default pairing code is 0000. The pairing code can be changed later in the web interface.
5 Once the pairing is finished, right click on the GR25/50 device listed in your Bluetooth devices panel and
select Connect.
6 Go to the Network connections panel of your computer and select the Bluetooth network connection
connected to the receiver. Right click and open the properties.
7 Highlight the TCP/IP connection and click on the Properties button.
Enter the IP address 192.168.253.x and subnet mask 255.255.255.0.
8
9 Open a browser and type in the IP address: 192.168.253.2 to access the Web interface.
10 Use the default User name (Admin) and Password (12345678).
After logging in the first time you must create a new user account, including a new user name and password.
The
default user account can then be deleted. Refer to the GR/GM Operational Manual (Online Help) for a step-
by-step
guide.
11 Configure the instrument for all required settings.

Setup via Web interface over WLAN (GR25/50)

Only available for GR25/50 with WLAN radio installed.
Please note that this page describes a wireless ad-hoc connection to the default profile. For user defined ad-
hoc setups, please edit the described settings accordingly.
Step Description
1 Turn on the receiver.
2 Use the arrow buttons, go to Configuration / Network Config / WLAN and use the left button to enable the
WLAN radio.
A WLAN default profile is pre-configured on all GR25/50 with the WLAN hardware installed and the
GRL120 WLAN option installed.
3 Activate WLAN on your computer. It may be necessary to use a hardware or software switch.
4 On your computer, go to Start > Control panel > Network and Sharing Center.
5 Select to set up a new network.
6 Create a new wireless ad hoc (computer-to-computer) network.
7 Choose the security type to be "No authentication (Open)" and leave the security key field blank.
Enter the receiver's serial number for the network name.
8 Edit the network settings of your computers WLAN adapter:
IP address: 192.168.252.x
a. Left button
b. Right button
c. Up button
d. Cancel button
e. Down button
f. Enter button
g. Screen
h. ON/OFF button
5: Getting started
51