Setting Descriptions - Leica GR30 Online Help Manual

The FTP server configuration page is used to enter the necessary information for accessing the receiver's FTP server (attached storage
devices).
The FTP server can also be accessed via a TCP/IP connection over USB cable. The settings for this connection are hard wired.
For more information on setting up a USB connection, see Setup via Web Interface over USB.
Mozilla Firefox does not support the use of certain ports. Use a different internet browser if these ports need
to be used. Ports blocked by default in Mozilla Firefox browser.
When accessing the FTP server the following wildcards can be used together with the DIR command:
•
dir *.zip
•
dir New*
•
dir Newton_5?8.zip
•
dir *ton_588.zip
•
dir *ton_588.*
•
dir *207k*

Setting Descriptions

The table below describes the fields in the FTP server page.
Setting
Enable FTP server
Allow anonymous access
Control connection port
Data connection port range
(passive mode)
Session timeout
Restore default
values
Description
Turn the FTP server on or off on the receiver. If disabled, FTP access to the receivers
attached storage devices is not possible.
Activate to allow read only access to anonymous users.
Enter the TCP/IP port where the FTP server listens for incoming connections.
Default: 21
Enter the TCP/IP port range used for passive mode data transfers.
Default: 50000 - 51000
For an active mode transfer the port number <control
connection port - 1> is used (default: 20).
Select the time in seconds after which the FTP server drops inactive connections.
Default: 180
A maximum of 6 simultaneous connections is possible on the GR/GM receiver FTP
server.
Press to fill the form with factory default settings and store.
The restore default button fills all fields with the default
values and stores these values. Pressing the save button is
not necessary. When accepting the confirmation message,
all settings on this page are overwritten with the default
settings.
6: Context sensitive help
177