Related Topics; Network Connections: Mobile Internet; Background Information; Setting Descriptions - Leica GR30 Online Help Manual

Renew DHCP lease
Trouble-shooting
If you are not able to connect to your receiver via ethernet, please try the following:
•
If the receiver has a static IP address, use this address and not the hostname.
•
After you changed the ethernet configuration or the hostname of a receiver, call ipconfig /flushdns
in a command prompt on the computer where you want to access the receiver. Otherwise the
computer may use the local DNS cache to resolve the IP address.
If Residential Gateway is enabled and the Ethernet device is used as LAN interface, turning on DHCP may
prevent Residential Gateway setup to work properly.
Please refer to the Residential Gateway Online Help page for more information.

Related topics

Receiver setup: DynDNS
Use DHCP to automatically assign an IP address and all network parameters to a instrument
Use a hostname to access a instrument with a static IP address
Receiver Setup: Residential Gateway

Network connections: Mobile Internet

Background Information

Configure mobile Internet access (e.g. via GPRS device) to the receiver.

Setting Descriptions

The table below describes the settings that can be configured on the Mobile Internet page.
Configure device for Internet usage
Device
Pin code
Puk code
146
button is not necessary. When accepting the
confirmation message, all settings on this page are
overwritten with the default settings.
Press to trigger a renewed IP address from the DHCP server.
This option is only available when the Obtain IP address automatically check
box is active.
Description
Select the device to be used to connect the receiver to the Internet. All
phone/modem devices configured in the device management with mobile
Internet capability are listed.
When Not used is selected, all fields below are hidden.
For using a non-default device, the device must be
configured in advance, via Device Management.
Enter the pin code for the used SIM card.
Enter the Puk code for the used SIM card. Usually this field can be left blank.