I/O Configuration And Model Number Legend; I/O Configuration - Omron E5*C Series User Manual

1-2 I/O Configuration and Model Number
Legend
1-2-1

I/O Configuration

Inputs
Input signals
Local SP
Set point (SP)
Multi-SP
Remote SP
Analog input (current/voltage)
Potentiometer input
Process value (PV) input
• Thermocouple
• Resistance thermometer
• Input type
• Infrared Temperature Sensor
• Input filter
• Analog input (current/voltage)
• Extraction of square root
Event inputs (EV1 to EV6)
• RUN/STOP switching
• External inputs
• Program start
(contact or non-contact input)
• SP mode (remote/local
switching)
• 100% AT execute/cancel
• Setting change
enable/disable
• Alarm latch cancel
Input voltage from CT
CT input
Setting and monitoring
Setup Tool (CX-Thermo)
Power supply
A: 100 to 240 VAC
or
D: 24 VAC/DC
Note: Not all models support these functions. For details, refer to 1-2-2 Model Number Legends.
E5@C Digital Temperature Controllers User's Manual (H174)
E5@C
Control
SP mode
• SP ramp
• Set point limiter
SP
FB
• Input shift PV
• Moving average
• Analog scaling
• Auto/manual selection
Automatic setting of
• Invert direct/reverse
PID constants with AT
operation
or ST
• 40% AT execute/cancel
• Standard control or
• Communications • Heating/cooling
write enable/disable control
• Multi-SP No.
Alarms
• HB alarm
• HS alarm
Heating
Open
Limits Operation
Manipulated
• MV limit
value
• Direct/reverse
• MV
(MV)
• Auto/manual
rate-of-
change limit
Cooling
Close
Contact status
• Standard alarms (alarms 1 to 4)
• HB alarm
• HS alarm
• Input error (S.ERR)
• RSP input error
• Integrated alarm
•
RUN status
• Program end
• Work bits 1 to 8
Analog status
• Set point
• Set point during SP ramp
• Process value
• Manipulated value
* Functions can be assigned individually for each output by
changing the set values for the Control Output 1 and 2
Assignments and the Auxiliary Output 1 to 4 Assignments in the
parameters in the advanced function setting level.
1 Introduction
1
Outputs
Output signals
• Linear current
Control output 1
• Voltage output
(for driving SSR)
• Relay
*
• Linear current
Control output 2
• Voltage output
(for driving SSR)
• Relay
*
Auxiliary outputs 1 to 4
• Relay
*
Transfer output
• Linear current
• Linear voltage
• CompoWay/F
Communications
• Modbus-RTU
• RS-485
1 - 5