Omron E5*C Series User Manual page 346

6 Parameters
mani
This parameter sets the initial value of the manual MV to use after control moves from Auto-
matic Mode to Manual Mode.
Function
Standard control: −5.0 to 105.0
Setting
Heating/cooling control: −105.0 to 105.0
If the Manual MV Limit Enable parameter is set to ON, the setting range will be the MV
lower limit to the MV upper limit.
 Related Parameters
See
See
Manual Output Method (Advanced Function Setting Level): Page 6-75
Manual MV Limit Enable (Advanced Function Setting Level): Page 6-88
6 - 76
Manual MV Initial Value
Setting range
Control must be set to 2-PID control.
A Position-proportional Model set to Close Control
with the Direct Setting of Position-proportional MV
parameter set to ON must be used.
Unit Default
% 0.0
E5@C Digital Temperature Controllers User's Manual (H174)