Fuel Level Sensor - Subaru Legacy 2003 Service Manual

FUEL INJECTION (FUEL SYSTEMS)

23.Fuel Level Sensor

A: REMOVAL
WARNING:
• Place "NO FIRE" signs near the working area.
• Be careful not to spill fuel on the floor.
NOTE:
The fuel level sensor is built in fuel pump assembly.
1) Remove the fuel pump assembly. <Ref. to
FU(H4SO)-62, REMOVAL, Fuel Pump.>
2) Disconnect the connector from fuel pump brack-
et.
3) Pushing the pawls with a screwdriver, remove
the fuel meter unit by pulling it downwards.
NOTE:
Replace the fuel filter pawls with new ones as they
might brake when removed.
FUEL LEVEL SENSOR
B: INSTALLATION
Install in the reverse order of removal.
WARNING:
• Ground cable must be connnected.
• Spark may occur and ignite if fuel is nearby.
FU-00680
FU-00681
FU(H4SO)-64
FU-00682