Subaru Legacy 2003 Service Manual page 138

(4) Tighten the throttle position sensor holding
screws.
Tightening torque:
1.6 N·m (0.16 kgf-m, 1.2 ft-lb)
4) When using Subaru Select Monitor;
(1) Turn the ignition switch to OFF.
(2) Loosen the throttle position sensor holding
screws.
NOTE:
For detailed operation procedures, refer to the
Subaru Select Monitor Operation Manual.
(3) Insert the cartridge to the Subaru Select
Monitor.
THROTTLE POSITION SENSOR
FU-00291
FU-00291
ST
FU-00293
FU(H4SO)-31
FUEL INJECTION (FUEL SYSTEMS)
(4) Connect the Subaru Select Monitor to the
data link connector (A).
( A )
5) Turn the ignition switch to ON, and the Subaru
Select Monitor switch to ON.
6) Select the {2. Each System Check} in Main
Menu.
7) Select the {Engine Control System} in Selection
Menu.
8) Select the {1. Current Data Display & Save} in
Engine Control System Diagnosis.
9) Select the {1.12 Data Display} in Data Display
Menu.
10) Adjust the throttle position sensor to the proper
position to match with the following specifications.
Condition: Throttle fully closed
Throttle opening angle 0.00%
Throttle sensor voltage 0.50 V
11) Tighten the throttle position sensor holding
screws.
Tightening torque:
1.6 N·m (0.16 kgf-m, 1.2 ft-lb)
EN-00710
FU-00291