Subaru Legacy 2003 Service Manual page 258

5) Install the A/C compressor bracket on cylinder
head.
6) Install the intake manifold. <Ref. to FU(H4SO)-
17, INSTALLATION, Intake Manifold.>
7) Install the camshaft
ME(H4SO)-51, INSTALLATION,
Sprocket.>
8) Install the timing belt assembly. <Ref. to
ME(H4SO)-47, INSTALLATION, Timing Belt As-
sembly.>
9) Install the belt cover. <Ref. to ME(H4SO)-45, IN-
STALLATION, Belt Cover.>
10) Install the crankshaft
ME(H4SO)-43, INSTALLATION, CRANKSHAFT
PULLEY.>
11) Install the V-belt. <Ref. to ME(H4SO)-42, IN-
STALLATION, V-belt.>
C: DISASSEMBLY
1) Place the cylinder head on ST.
D: ASSEMBLY
( 1 )
(1) Valve
(2) Valve guide
(3) Valve spring seat
(4) Oil seal
(5) Valve spring
CYLINDER HEAD ASSEMBLY
sprocket. <Ref. to
Camshaft
pulley. <Ref. to
( 3 )
( 4 )
( 2 )
( 9 )
(10)
(6) Retainer
(7) Retainer key
(8) Spark plug gasket
(9) Camshaft
(10) Oil seal
ME(H4SO)-61
ST 498267800 CYLINDER HEAD TABLE
2) Set the ST on valve spring. Compress the valve
spring, and then remove the valve spring retainer
key. Remove each valve and valve spring.
ST 499718000 VALVE SPRING REMOVER
CAUTION:
• Mark each valve to prevent confusion.
• Use extreme care not to damage the lips of in-
take valve oil seals and exhaust valve oil seals.
ST
( 8 )
( 5 )
( 7 )
(11)
(12)
( 6 )
(11) Plug
(12) Camshaft cap
(13) Valve rocker ASSY
MECHANICAL
ME-00280
(13)
ME-00281