Subaru Legacy 2003 Service Manual page 52

1. APPEARANCE CHECK
1) When vehicle is covered with protective film, in-
spect visually for damage or dents to vehicle body
surface.
2) When protective film is removed, check the body
paints for small areas of damage or stains and re-
pair as necessary.
3) Check the window glass, door glass, and lights
for any cracks or damage and repair or replace the
parts as necessary.
4) Check the plated parts, such as the grilles and
door knobs, for damage or loss of gloss and repair
or replace the parts as necessary.
2. TIRE CHECK
• Check the tire outer faces for any damage.
• Check the tire air pressure by referring to the fol-
lowing table.
Tire size
195/60R15 220 (2.2, 32)
205/50R16 230 (2.3, 33)
215/60R16 200 (2.0, 29)
215/45ZR17 230 (2.3, 33)
3. FUSE INSTALLATION
A vehicle just delivered has no fuses for the room
lamp circuit to prevent battery discharge. Attach a
15 A fuse as shown in the figure.
4. CONNECTION OF AIR CONDITIONER
CUT CONNECTOR
A vehicle just delivered has its air conditioner cut
connector or air conditioner haness disconnected
to protect the air conditioner compressor. Connect
as shown in the figure.
PRE-DELIVERY INSPECTION
Tire inflation pressure
2
kPa (kg/cm , psi)
Front Rear
210 (2.1, 30)
220 (2.2, 32)
190 (1.9, 28)
220 (2.2, 32)
( A )
PI-00085
3.0 L model
Except 3.0 L model
5. CHECK THE DOOR OPERATIONS,
LOCK/UNLOCK AND OPEN/CLOSE, AS
FOLLOWS.
Using the key, lock and unlock the door several
times to check for normal operation. Open and
close the door several times for smooth movement.
(A) Unlock
(B) Lock
• Vehicles with manual door locks:
Sit in all the seats, close the door completely, and
move the lock lever to the lock position. Then, pull
the inside door handle to ensure the door will not
open.
PI-5
PRE-DELIVERY INSPECTION
PI-00115
PI-00002
( A )
( B )
PI-00087